Hiniker 9850, Руководство оператора

Страница: 19 / 33

V-Plow Assembly 17
NOTE: To prevent corrosion lightly coat all elec-
trical connections, ring and spade terminals with
dielectric grease prior to assembly.
DWG. NO. 5849B
Refer to drawing 5849. Attach the ring termi-
nal of the solid red (or red striped) wire of the
power cable assembly to the terminal on the
motor at location 1.
Fasten the ring terminal of the solid black wire
of the power cable assembly, the black wire
with the ring terminal on the plow harness, and
the ring terminal of the ground wire harness to
the terminal on the motor at location 2.
Attach the coil ground wire harness as
shown.
DWG. NO. 5844B
Connect the Tan wire of the wiring harness
to the spade terminal on solenoid S1.
Connect the Pink wire to solenoid S2.
Connect the Gray wire to solenoid S3.
Connect the Brown wire to solenoid
S4.
Connect the Blue with White stripe wire to
solenoid S5.
Connect the Blue wire to solenoid S6.
Connect the RH headlamp to the har-
ness end labeled “PSNGR SIDE” and the
LH headlamp to the end labeled “DRIVER
SIDE”.
DWG. NO. 6013B
Refer to drawing 6013A. Use a plastic tie
strap to band the plow wiring harness to the
lift frame tube at location 3. Route wires to the
power unit and headlamps, as shown.
NOTE: Install the plow harness so that water
does not run down the wires and pool inside
the “Y” connection. Position the harness so
that any trapped water can easily drain away.