Hilti TE 60, Оригинальная инструкция по эксплуатации

Страница: 30 / 118

Fault Possible cause Remedy
No hammering action. The power tool is too cold. Allow the power tool to warm up to
the minimum operating temperat-
ure.
See section: 7.2.2 Hammer
drilling
6
The power tool doesn’t start
and the LED blinks red. A fault has occurred in the power
tool. If necessary, the power tool should
be repaired by Hilti Service.
The power tool doesn’t start
and the LED lights red. The carbon brushes are worn. Have it checked by a trained elec-
trical specialist and replaced if ne-
cessary.
The power tool doesn’t start
and the indicator lamp blinks
yellow. The power tool has not been un-
locked (applies to tools with the
theft protection system (ATC)).
Use the TPS key to unlock the
power tool.
The power tool doesn’t
achieve full power. The extension cord is too long or
its gauge is inadequate. Use an extension cord of an ap-
proved length and / or of adequate
gauge.
The control switch is not pressed
fully. Press the control switch as far as it
will go.
The “Reduced power” button is
active (ATC). Press the “Reduced power” button.
The voltage provided by the electric
supply is too low. Connect the power tool to a differ-
ent power source.
The drill bit doesn’t rotate. The function selector switch is not
engaged or is in the “Chiseling” or
“Chisel adjustment” position.
When the motor has stopped,
move the function control switch
to the “Drilling without hammering”
or “Hammer drilling” position.
The drill bit / chisel can’t be
released from the chuck. The chuck is not pulled back fully. Pull the chuck back as far as it will
go and remove the insert tool.
The side handle is not fitted cor-
rectly. Release the side handle and refit
it correctly so that the clamping
band and side handle engage in the
groove.
10. Disposal
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, Hilti has already made
arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer
service department or Hilti representative for further information.
en
30