Hilti TE 30-A36, Руководство по эксплуатации

Страница: 10 / 314

CAUTION
Wear protective gloves when inserting the battery.
1. Push the battery into the power tool from the rear
until it is heard to engage with a double click.
2. CAUTION A falling battery may present a risk
of injury to yourself or others.
Check that the battery is seated securely in the
power tool.
6.4 Removing the battery
3
1. Press one or both release buttons.
2. Pull the battery out of the power tool toward the
rear.
6.5 Transport and storage of battery packs
4
Pull the battery pack out of the locked position (work-
ing position) and move it into the first click-stop
position (transport position).
If you disconnect a battery pack from the power tool
for transport or storage, make sure that the contacts
of the battery pack are not short-circuited. Remove
loose metal parts such as screws, nails, clamps,
loose screw bits, wires or metal swarf from the case,
toolbox or transport container, or prevent these parts
from coming into contact with the battery packs.
Observe national and international transport regula-
tions when shipping battery packs (transportation by
road, rail, sea or air).
6.6 Fitting the side grip
5
CAUTION
Remove the depth gauge from the side handle in
order to avoid injury.
1. Set the forward / reverse switch to the middle
position or remove the battery from the power
tool.
2. Release the side grip clamping band by turning
the grip counterclockwise.
3. Slide the side grip clamping band over the chuck
and onto the shaft.
4. Pivot the side grip into the desired position.
5. Slide the depth gauge to the desired position.
6. Secure the side handle by turning the grip clock-
wise.
7. Check that the clamping band is correctly located
in the groove provided.
6.7 Dust removal (TE DRS
‑
S)
A DRS dust removal head can be fitted to the depth
gauge of the side handle. Drilling dust and frag-
ments can then be removed by a vacuum cleaner.
For further information on operation and use of the
dust removal system, please refer to the separate
operating instructions for the TE DRS
‑
S.
7. Operation
CAUTION
In the event of the drill bit sticking, the power tool
will pivot about its own axis.
Always use the power
tool with the side handle fitted and hold it securely
with both hands so that the resulting opposing force
causes the slip clutch to release in the event of the
drill bit sticking. Use clamps or a vice to hold the
workpiece securely.
7.1 Preparing for use
7.1.1 Adjusting the depth gauge
6
1. Release the side grip clamping band by turning
the grip counterclockwise.
2. Pivot the side grip into the desired position.
en
10