![background image](http://html.mh-extra.com/html/hilti/sfd-22-a/sfd-22-a_manual_2135336024.webp)
20
English
2169940
*2169940*
8
Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport
!
▶
Always transport your products with the batteries removed!
▶
Remove the battery.
▶
Never transport batteries in bulk form (loose, unprotected).
▶
Check the tool and batteries for damage before use after long periods of transport.
Storage
WARNING
Accidental damage caused by defective or leaking batteries
!
▶
Always store your products with the batteries removed!
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
9
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact
Hilti
Service.
9.1
Troubleshooting
Trouble or fault
Possible cause
Action to be taken
The power tool does not
work.
The battery is not fully inserted.
▶
Push the battery in until it
engages with an audible double
click.
Battery is discharged.
▶
Change the battery and charge
the empty battery.
Electrical fault.
▶
Remove the battery from the
tool and contact
Hilti
Service.
The power tool does not work
and one LED flashes.
Battery is discharged.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold.
▶
Bring the battery to the recom-
mended operating temperature.
The on/off button cannot be
pressed, i.e. the button is
locked.
The forward/reverse switch is in
the middle position.
▶
Push the forward/reverse switch
to the left or right.
LED 1 flashes
Battery is discharged.
▶
Change the battery and charge
the empty battery.
The tool is overloaded (application
limits exceeded).
▶
Pay attention to the power
and performance rating of the
product before using it, i.e
check its suitability for the job
on hand. See the “Technical
data” section.
The battery runs down more
quickly than usual.
Very low ambient temperature.
▶
Allow the battery to warm up
slowly to room temperature.
The battery does not engage
with an audible double click.
The retaining lugs on the battery
are dirty.
▶
Clean the retaining lugs and
push the battery in until it
engages. Contact
Hilti
Service
if the problem persists.
Содержание SFD 22-A
