![background image](http://html1.mh-extra.com/html/hilti/sc-5ml-22/sc-5ml-22_operating-instructions-manual_2136389035.webp)
*2276671*
2276671
English
29
5.7
Adjusting the cutting depth
1. Release the cutting depth adjustment clamping lever.
2. Lift the product in a scissoring movement and set the cutting depth.
3. Tighten the cutting depth adjustment clamping lever.
5.8
Installing fence
1. Squeeze the clip together and hold it in this position.
2. Push the fence into the base plate.
▶
You can set the cutting width to suit your application.
3. Release the clip.
5.9
Installing guide rail adapter
The guide rail adapter is available as an accessory.
1. Remove the fence, if fitted.
2. Hook the base plate into the rear retaining lugs of the guide rail adapter.
3. Set the base plate down on the guide rail adapter.
▶
The base plate is flush on the guide rail adapter.
4. Lock the guide rail adapter by pressing in the two sliders as far as they will go.
5.10
Emptying the chip collector
WARNING
Risk of injury!
Hot or sharp metal cuttings / chips present a hazard.
▶
Wear protective gloves when emptying the chip collector.
1. Pull the chip collector away from the tool to the rear.
2. Swing the two halves of the chip collector apart and empty out its contents.
3. Push the chip collector onto the guard until in engages in position.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Switching on or off
Switching on
1. Press and hold down the switch-on interlock and press the on/off button.
▶
You can release the switch-on interlock as soon as you have the on/off switch held down.
Switching off
2. Release the on/off switch.
▶
The switch-on interlock jumps automatically into the locked position.
6.2
Sawing along a line
Saw only flat workpieces that offer a big enough contact surface to accommodate the whole of the
base plate.
1. Position the workpiece so that the saw blade is free to rotate beneath it.
2. Secure the workpiece to prevent movement.
3. Bring the front edge of the base plate into contact with the workpiece.
▶
Saw blade clear of the workpiece.
4. Switch the product on. → page 29
5. Guide the saw along the cutting line at a suitable speed for it to cut smoothly through the workpiece.
Содержание SC 5ML-22
