Hilti PR 2-HS A12, Руководство по эксплуатации

Страница: 14 / 20

12 English
6 Operating the laser receiver
6.1 Inserting the batteries in the laser receiver
▶
Insert the batteries in the laser receiver.
Note
Use only batteries that have been manufactured in accordance with international standards.
6.2 Using the laser receiver to detect the laser beam
1. Press the button on the laser receiver.
2. Hold the laser receiver with the receiving window directly in the plane of the laser beam.
3. Hold the laser receiver still while alignment is taking place and take care to ensure that the line of sight
between the laser receiver and the tool is not obstructed.
◁
Detection of the laser beam is indicated by visual and audible signals.
◁
The laser receiver indicates the distance to the laser beam.
6.3 Setting the units to be used
1. When switching the laser receiver on, press and hold the
button for two seconds.
◁
The menu is then shown in the display.
2. Use the
button to toggle between metric or imperial measuring units.
3. Switch the laser receiver off by pressing the
button.
◁
The settings will be saved.
6.4 Changing the units used by the laser receiver
1. Switch the laser on. → page 9
2. Press the button repeatedly.
◁
The desired accuracy (mm/cm/off) is shown alternately in the digital display.
6.5 Adjusting the volume level on the laser receiver
1. Switch the laser on. → page 9
2. Press the
button repeatedly.
◁
The desired volume level (low/normal/high/off) is shown alternately in the digital display.
Note
The laser receiver is set to “Normal” volume when switched on.
6.6 Adjusting the signal tone on the laser receiver
1. When switching the laser receiver on, press and hold the
button for two seconds.
◁
The menu is then shown in the display.
2. Use the
button to assign the rapid signal tone to the upper or lower detection area.
Printed: 31.07.2017 | Doc-Nr: PUB / 5260662 / 000 / 01