![background image](http://html1.mh-extra.com/html/hilti/nuron-ncr-60-d-22/nuron-ncr-60-d-22_original-operating-instructions_2135091027.webp)
*2321724*
2321724
English
23
The factory default is starting lock deactivated.
1. Remove the battery. → page 22
2. Press and hold down the control switch.
3. Insert the battery into the crimping tool.
4. Release the control switch.
▶
The green LED flashes twice; acoustic signal sounds twice: starting lock activated
▶
The green LED flashes twice; acoustic signal sounds once: starting lock deactivated
5.5
Fall arrest
WARNING
Risk of injury
by falling tool and/or accessory!
▶
Use only the
Hilti
tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the
Hilti
retaining strap and the
Hilti
tool tether
#2261970.
▶
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the
Hilti
retaining strap and those of the
Hilti
tool tether.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Performing crimping operation
DANGER
Electric shock hazard!
Working in adverse outdoor conditions can cause electric shocks and/or short
circuits.
▶
Never work on electrically live lines while a thunderstorm is in progress.
▶
Call a halt to work immediately whenever weather conditions impair the insulation characteristics, vision
or movement of the workers.
WARNING
Risk of burn injury due to faulty crimping operations.
Burns can result.
▶
Use crimping terminals of the correct type and size for the cable and use with the corresponding crimping
dies.
▶
Before every crimping operation, make sure that pivoting bar and lever are securely engaged.
▶
Listen for the acoustic signal and check that the piston has retracted. If no acoustic signal sounds and/or
the piston does not retract, the crimping operation is faulty.