Hilti DX 9-HSN, Оригинальная инструкция по эксплуатации

Страница: 25 / 72

*2194029*
2194029 English 17
3. Pull the catch out and hold it in this position. If the tool does not open up by itself try pulling it open,
without applying more than ordinary muscle power.
Result 1 / 2
The tool can be pulled open.
▶
Proceed to the next step in the procedure.
Result 2 / 2
The tool cannot be pulled open.
▶
Do not proceed.
▶
Lay the tool aside in such a way that if the cartridge were to trigger in the tool there is no possibility
of injury to persons or damage to property, and secure the tool in such a way that no-one else has
access to it.
▶
Notify Hilti Service immediately.
4. Remove the cartridges from the tool. → page 13
5. Disassemble the base plate. → page 14
6. Check the piston and piston brake and replace these parts if necessary. → page 13
7. Clean the fastening tool. → page 14
8. Close the rotating sleeve. → page 11
8.3 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The cartridges are not trans-
ported.
The cartridge strip is damaged.
▶
Change the cartridge strip. Do
not attempt to forcibly remove
cartridges or the cartridge strip.
The tool is damaged.
▶
Contact Hilti Service.
The cartridge strip cannot be
removed.
The tool is damaged.
▶
Contact Hilti Service.
The tool doesn’t fire. Misfire
▶
Remedy the malfunction.
→ page 16
The cartridge strip is used up.
▶
Remove the cartridge strip from
the tool.
▶
Insert a new cartridge strip.
There are less than 15 fasteners in
the tool.
▶
Load new fastener strips.
The tool is not adequately com-
pressed.
▶
Press the nose of the tool
against the working surface
again and pull the trigger.
Fastener transport malfunction.
▶
Check that the fastener strips
are free to move.
▶
Remove any damaged or
defective cartridge strips or
strips containing damaged or
defective fasteners.
The tool is clogged with dirt.
▶
Clean the tool.
The cartridges are unsuitable.
▶
Contact Hilti Service.
▶
Do not attempt to forcibly
remove cartridges or the
cartridge strip.
The tool is damaged.
▶
Contact Hilti Service.
Insufficient nail stand-off
The fastener missed the beam.
▶
Mark the position of the beam
and drive another fastener.
Driving power is too high.
▶
Reduce the driving power
(adjust the power regulation) or
use less powerful cartridges – if
available.