Hilti DX 9-HSN, Оригинальная инструкция по эксплуатации

Страница: 19 / 72

*2194029*
2194029 English 11
5.4 Loading cartridge strips 3
1. Insert the cartridge strips from above in the cartridge loading channel.
Materials
6.8/11 M40 red or other cartridges of a type approved for use with the tool (please refer to the car-
tridge recommendations printed in the instructions for use of the fasteners)
2. Press the cartridge strip into the cartridge loading channel until it lies flush with the top edge of the
cartridge loading channel.
5.5 Opening the rotating sleeve 4
▶
Turn the rotating sleeve as far as it will go. Use the scraper or some other tool as an aid, if necessary.
If the fastening tool is jammed, it will then be possible to access the catch.
5.6 Closing the rotating sleeve 5
▶
Turn the rotating sleeve as far as it will go. Use the scraper or some other tool as an aid, if necessary.
If the rotating sleeve is not fully closed it will not be possible to press the fastening tool fully against
the working surface and, accordingly, the tool cannot be operated.
5.7 Installing protective cap 6
Before beginning work, check the protective cap for damage.
CAUTION
Risk of burns! Parts of the tool may be very hot after the tool has been in use.
▶
If it is necessary to carry out maintenance without first allowing the tool to cool down, it is essential that
protective gloves are worn.
1. Remove the magazine and cartridges.
2. Introduce the front nose into the front mounting adapter.
3. Introduce the nose with T-head into the rear mounting adapter.
4. Repeat the procedure on the opposite side.
5. Check that all the noses are correctly seated in their corresponding mounting adapters.
6 Operation
WARNING
Risk of injury by accidental triggering! A loaded fastening tool can be made ready to fire at any time.
Accidental triggering can endanger you and others.
▶
Always unload the fastening tool (cartridges and fasteners) whenever you interrupt work with the fastening
tool.
▶
Before all maintenance, cleaning and setup activities, always make sure that there are no cartridges and
no fasteners in the fastening tool.
WARNING
Hazard due to hot surfaces! The fastening tool can become hot in use.
▶
Wear protective gloves.
If resistance is unusually high when you insert the cartridge strip, check whether the cartridge strip is
compatible with this fastening tool.
Always use the protective cap for work that can produce flying splinters.
Observe the safety instructions and warnings in these operating instructions and on the product.