Hilti DS TS 5-SE, Руководство по эксплуатации

Страница: 13 / 40

13
Technical data and description
Display, symbols and warning lamps on the DS-RC-TS 5-E
No. Designation Function
쐎
Saw blade drive speed indicator
I
Green LED indicates the saw blade speed during
operation, set by adjusting control
���
.
쐅
Saw blade speed (rpm) range,
I
Recommended speed (rpm) ranges for Hilti saw
500 mm and 700/745 mm dia. blades
쐈
Temperature indicator
I
Lights when the machine overheats. Switches off
automatically if no reaction from operator.
쐉
Water cooling
I
Lights / blinks when cooling of machine is inade-
quate, i.e. water too warm or insufficient
씈
Zero position
I
Lights when one of the controls is not in “0” or
“neutral” position when machine is switched on.
씉
Emergency OFF
I
Lights when emergency OFF is pressed.
씊
Mains supply / warning lamp
I
Lights when machine is still not ready for operation.
I
Lights when problem with mains voltage.
I
Blinks to indicate electrical fault in DS TS 5-SE.
씋
Operating hours
I
The present operating hours total is displayed when
the machine is switched on.
Power output
I
During sawing, power output of the saw blade drive
is displayed, e.g. 100%
Supplied voltage
I
During sawing, supplied voltage is displayed when
ON/OFF switch
쐃
is turned to “start”
Fault indicator
I
Displays the applicable error message e.g. “Er01”.
씌
Warnings
I
Do NOT operate the wall saw without the blade
guard and rail end stops in position!
씍
Service indicator
I
Lights up after 100 operating hours, Service is
recommended
Operating controls on the DS TS 5-SE saw head
No. Designation Function
쐃
Main switch Turn to position “0” to disconnect power from the
complete system (incl. remote control unit).
Note: The main switch always returns (from “0” or “I”)
to the middle position when released.
Turn to position “I” to switch on. The system is ready
for operation after approx. 10 sec. The indicators on
the remote control unit are tested automatically during
these 10 sec., as follows:
1. Green LED, saw blade speed (rpm)
2. All red warning lamps
3. The digital display
4. The operating hours indicator
The mains supply warning lamp extinguishes when
the machine is ready for operation.
쐇
Water regulation valve Position towards saw arm = all cooling water is directed
to the saw blade. Intermediate positions are possible.
5.2
5.3