The connection X3 of the PKV 30-COS is meant for
communication operation
or for
diagnostic/configuration operation
When switching on the 30-COS a check is carried out at the X3 connection whe-
ther the diagnosis/configuration operation is to be started. In the other case, com-
munication operation is taken up.
2.4.1 Activating the diagnostic/configuration operation
The diagnosis cable must be connected to X3 at the Protocol Converter and to the
COM1 (or COM2) of the PC.
Start ComPro program with
COMPRO /S:1 or
.
COMPRO /S:2
(for COM1 or COM2).
Select menu
Online - System - Bootstart
first. The window with the:
The system
will be reseted and the bootloader becomes active without startinmg any firmwa-
re
message appears.
Now switch off the currant at the Protocol Converter and wait at least for 10
seconds.
In the ComPro confirm the:
The system will be reseted and the bootloader be-
comes active without startinmg any firmware
message with Return. A red win-
dow appears with the message:
Waiting for hardware receipt
.
Then the voltage at the Protocol Converter is switched on again.
The red window in the ComPro must disappear.
In order to test whether the Protocol Converter is in diagnostic operation, select
the
Online - System - Firmware
menu sequence. When the information of the
Firmware in the Converter appears, then the diagnostic/configuration operation
has been successfully activated. If the:
No connection could be built up
message
appears, then the steps described for activating the diagnostic/configuration ope-
ration must be carried out again.
When the interface type
RS422 or RS485 is configu-
red, it is
not necessary
to
change this configuration for
diagnostic operation.
General Device Description
13
Copyright * Hilscher Gesellschaft für Systemautomation mbH * Hotline/Support: +49(0)6190/9907-99 * De:P30COS#3E
