Hillyard TRIDENT XM13SC, Руководство по обслуживанию

Страница: 45 / 52

Maintenance
(to perform every 150h )
Replacing Squeegee Wheels
• Put the machine in safe conditions.
• Place the machine vertically.
•
Completely unscrew the nuts hold-
ing the squeegee wheels
• Remove and replace the squeegee
wheels
• Proceed at reverse to restore the
parts.
• When finished, repeat the operations
for the proper Squeegee adjustment
(see section 7.3.1 at page 44 )
.
7.4.2 Squeegee Support
Check
(to perform every 50h )
The squeegee support must be free to
move and to pivot along the holding
central axis to fit to the floor.
7.4.3 Suction Hose and Duct
Check
(to perform every 2h )
The suction hose has to be clean and
intact. It is mandatory that the hose has
no crack to not decrease the underpres-
sure.
The suction hose is particularly
sensitive in the coupling areas between
the pipe and couplings and in tight
curves.
The Suction Duct and its top
and bottom gaskets must be clean and
intact.
7.4.4 Suction Cover and
Floaters
Check
(to perform every 2h )
The suction cover have to be clean to
allow the full passage of water and air
through its conveyor compartments.
The floaters has to be clean and it is
important that no external debris or
causes block or reduces the floaters mo-
bility. It is Mandatory that the floaters
be free to move and have to block com-
pletely the water/air flow when it is in
blocking position (UP).
Maintenance
(to perform every 2h )
• Put the machine in safe conditions.
•
Remove the suction cover.
• With a water jet, clean the floaters
and the rotation fulcrum of the
floaters.
• With a water jet, clean the dirty
water conveyor compartment, both
from the inlet hole and from the out-
put one.
45