37
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
Figure 3-3: Installing the Rack-mounting Ears (1U Chassis as example)
Step 3: Two person are needed to cooperate to raise the device and place it to the
tray of the rack (or two person place the device to the tray of lift first, then use the
lift to achieve it).
Step 4: Keep the center of the rack-mounting ear and the center of the rack hole
horizontally even and tighten the screws, as shown in Figure 3-4.
Figure 3-4: Installing the Device in a Rack (1U Chassis as example)
Cautions:
The rack-mounting ears cannot bear weight. Make sure the chassis is
supported by the platform under it when mounted into a rack.
For better ventilation, there should be a clearance space between two
equipments.
If the rack accommodates only one device, put the device on the
bottom.
The floating nuts in the accessory box can only fit in the 9mm x 9 mm
squared holes of standard racks and they can be used when no original
rack nuts are available.
Connecting Cables
This section describes how to connect cables to the device, including connecting the
ground wire, the console cable, the Ethernet cable and the power cable.
