6
Assembly
Wire Assembly
1.
Unroll the wire.
Start with the innermost circuit
Thread wire through each staple
Take up any ‘slack’ and at each staple kink the
wire with your thumb to keep the line tight,
making sure the arms are not pulled out of
line with the opposite arm.
Cut the wire at approximately 125mm (5")
for tie off.
2.
Repeat step 1 for all other staples working
outwards from the centre.
Note:
square to each other when tensioning lines.
Always wear protective safety glasses when
‘wiring-up’ your clothesline.
Fig. 7
1. Feed the lines through the staples
Important:
Keep arms square to each
other when tensioning the lines.
2. Pull lines through staples, tension and
cut to length.
3. Tie lines onto arms.
12
5mm
(5"
)
cut
90°
Note: Each circuit is wired seperately. Wire cutters and pliers are needed to complete this job.
