13
OPERATION INSTRUCTIONS
3. Push in gas Control Knob and turn counterclockwise to
“IGNITER” then to “PILOT” (Figure b) to light the pilot. If needed,
keep depressing and turning Control Knob counterclockwise until
the pilot lights (You should heater 2 clicking sounds).
4. Once the pilot is lit, continue to depress the control Knob for
30 seconds.
5. If the pilot dose not stay lit, repeat steps 3 and 4.
Figure c
6. If after repeating steps 3 & 4 unit does not light, then
-Push in Control Knob and turn counterclockwise to “PILOT”.
-As you are depressing the Control Knob, place long stem lighter
into the ignition hole (Figure c) on the Emitter Screen to light the
pilot.
-Repeat step 4.
7. Push in and turn the Control Knob to the “LOW” position, then release Control Knob. If you want a
higher temperature,push in the Control Knob and turn counterclockwise to the “HIGH” position.
-The burner may be noisy when initially turned on, To eliminate excessive noise form the burner, set
the Control Knob to “LOW”, then turn the Control Knob to heat level desired.
White smoke may appear around the Emitter Screen during the first few minutes of initial lighting.
This is the heater burning up the oil used in manufacturing. Both smoke and odor will dissipate after
approximately 30 minutes.
After First Lighting
Note:
3
4
If pilot fails to remain lit, all valves should be closed and a waiting period of at least 5 minutes should
pass before attempting to light.
If you experience any ignition problem please consult “Troubleshooting” ” on page 17.
Caution:
Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning of
oils used in manufacturing will ap pear. Both smoke and odor will dissipate after approximately
30 minutes.The heater should NOT produce thick black smoke.
Note:
The burner may be noisy when initially turned on. To eliminate excessive noise from the burner,
turn the Control Knob to the Pilot position. Then, turn the knob to the level of heat desired.
Normal
Abnormal
