ASSEMBLY INSTRUCTIONS
6
7
5.Put the Glass Beads (Q) around the Burner (C).
6. Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.Use a
standard 20 lb. propane cylinder only. Use this heater
onlywith a propane vapor withdrawal supply system. See
chapter 5 of the standard for storage and handling of
liquefied petroleum gas, ANSI/NFPA 58. Your local library
or fire departmentshou.ld have this book.
Storage of an appliance indoors is permissible only if the
cylinder is disconnected and removed from the appliance.
A cylinder must be stored outdoors in a
well-ventilated are a out of the reach of children A
.
disconnected cylinder must have dust caps tightly
installed and must not be stored in a building, garage or
any other enclosed area. The maximum inlet gas supply
pressure: 250 psi. The minimum inlet gas supply
pressure: 5 psi .
The minimum hourly of 10000 Btu is the required input
rating for a heater for automatic operation at ratings less
than full input rating .
The pressure regulator and hose assembly supplied with
the appliance must be used.
The installation must conform with local codes, or in the
absence of local codes, with national fuel gas code, ANSI
Z223.1/NFPA54 , natural gas and propane.
InstallationCode, CSA B149.1, or propane storage and
handling code, B14 9.2.
10
Standard 20 lb. tank
Put the Burner Cover (A) on the burner,
when the Fire Pit is NOT in use or after use.
& Nut
Spring Washer
Washer,
Bolt(6*35mm),
J1
x 2
J
