HIKVISION iDS-TCM403-EIR/0411, Руководство пользователя, Страница: 27 / 87

The current radar status. The radar can be normally used in normal status. If the radar is in
upgrading status, do not reboot the device. Refresh the interface every one minute, and the
status can be restored to normal.
3. Click on the right of the interface and follow the wizard to set the parameters.
1) Set Number of Lane and the width of each lane.
2) Set Scene Mode according to the actual condition.
3) Set Vehicle Direction.
Approaching Direction
The vehicles are driven towards the construction position of the camera.
Leaving Direction
The vehicles are driven far away from the construction position of the camera.
Bidirection
There are vehicles driven both towards and far away from the construction position of the
camera.
4) Set Construction Height, Horizontal Correction, and Angle Deviation.
Construction Height
The construction height of the camera.
Horizontal Correction
It is the horizontal position deviation between the radar detected lane and the actual lane.
You can set it in two ways.
●
Method 1: Move the detected lane in the diagram leftwards or rightwards to overlap it
with the actual lane to correct the difference.
●
Method 2: Enter the horizontal distance (m) from the radar installation position to the
middle line of the actual lane to correct the difference.
Angle Deviation
It is the angle deviation between the radar detected lane and the actual lane. Rotate the
angle of the detected lane in the diagram to overlap it with the actual lane to correct the
difference.
5) Set the coordinate calibration and GPS calibration.
Note
Refer to Set Radar Calibration for details.
4. Set the other parameters.
Display Track
Enable the function, and the target track will be displayed on the interface according to the
detected coordinates.
Advanced Settings
Click Advanced Settings to set the advanced parameters.
Radar-Assisted Smart Monitoring Camera User Manual
17