HIKVISION DS-KIS701, Быстрый старт

Страница: 4 / 30

DS-KIS701 Video Intercom Bundle Quick Start Guide
QSG DS-KIS701 Video Intercom Bundle 080519NA 4
Symbol Conventions Symbol Conventions Symbol Conventions Symbol Conventions
The symbols that may be found in this document are defined as follows.
Symbol Symbol Symbol Symbol Description Description Description Description
Indicates a hazardous situation which, if not avoided, will or could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in equipment damage, data loss,
performance degradation, or unexpected results.
Provides additional information to emphasize or supplement important points of the main text.
Safety Instruction
Safety Instruction Safety Instruction
Safety Instruction
•
The working temperature of the indoor station is from -10° to 55° C.
•
The working temperature of the door station is from -30° to 60° C.
•
The working temperature of the video/audio distributor is from -10° to 55° C.
•
All the electronic operation should be strictly compliance with the electrical safety regulations, fire prevention regulations, and
other related regulations in your local region.
•
Please use the provided power adapter. The power consumption cannot be less than the required value.
•
Do not connect several devices to one power adapter as adapter overload may cause overheating or a fire hazard.
•
Make sure that the power has been disconnected before you wire, install, or dismantle the device.
•
When the product is installed on wall, the device shall be firmly affixed.
•
If smoke, odors, or noise rise from the device, turn off the power at once, unplug the power cable, and then contact the service
center.
•
If the product does not work properly, contact your dealer or the nearest service center. Never attempt to disassemble the device
yourself. (We shall not assume any responsibility for problems caused by unauthorized repair or maintenance.)
•
Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism radiation. Avoid the
equipment installation on surfaces subject to vibrations or places subject to shock (non-adherence can cause equipment
damage).
•
Do not place the device in extremely hot (refer to the specification of the device for the detailed operating temperature), cold,
dusty, or damp locations.
•
Keep the device cover away from rain and moisture.
•
Do not expose the equipment to direct sunlight, low ventilation, or a heat source such as a heater or radiator (doing so can
cause fire danger).
•
Do not aim the device at the sun or extra bright places. Blooming or smearing may occur (which is not a malfunction, however),
and affect the sensor endurance.
•
Use the provided glove when openng the device cover; avoid direct contact with the device cover, because the acidic sweat of
the fingers may erode the surface coating.
•
Use a soft and dry cloth when cleaning inside and outside surfaces of the device cover, do not use alkaline detergents.
•
Keep all wrappers after unpacking them for future use. In case any failure occurs, you must return the device to the factory with
the original wrapper. Transportation without the original wrapper may result in damage to the device and lead to additional
costs.
•
The power supply must conform to LPS. The recommended adaptor models and manufacturers are shown as below. Use the
attached adapter, and do not change the adaptor randomly.
M M M Model odel odel odel Manufacturer Manufacturer Manufacturer Manufacturer
KPL-060M-II Channel Well Technology Co., Ltd.