Quick Start Guide of Blazer Express Station
6
Basic Hardware Connection
Before you can access the station via network, you need to properly power on the
station and connect it to network.
Network Connection
Note:
Consult your network administrator before installing the station to avoid
possible network conflicts.
Use the network port on the rear panel and a network cable with RJ-45 connectors to
connect the station to your network.
Output Connection
Connect a VGA cable or HDMI
TM
cable to the video out interface (VGA or HDMI
TM
)
on the station.
Connect the VGA cable or HDMI
TM
cable to the display unit.
Hard Disk Installation
Before you start:
Disconnect the power from the Blazer Express before installing a hard disk drive
(HDD). A factory recommended HDD should be used for this installation.
Tools Required:
Screwdriver.
Steps:
1.
Remove the cover from the Blazer Express by unfastening the screws on the
back and side.
2.
Install the HDD using the provided screws and fasten the screws on the bottom
to fix the HDD.
3.
Connect the HDD to the motherboard of the Blazer Express with the included
data cable.
