HIKOKI UL 18DA, Инструкция по эксплуатации, Страница: 36 / 48

English
36
○ Be sure to use the cable provided.
Using a di ff erent cable could result in a fi re or accident due to overheating.
○ When the power plug is plugged into an outlet when a battery is installed, the battery will
charge whether the power switch is ON or OFF.
3. Power switch/mode setting
After connecting to a power source, switching the
power ON will operate the cooling/heating function.
Select and set your desired mode.
(1) Turn ON the power switch. The mode indicator
lamp and temperature indicator lamp will light up.
(The mode that will be indicated by the lamp will
be the mode that was previously set when the
unit’s power was last switched o ff .)
(2) Press the mode selector switch and choose
either COLD (green) or HOT (green).
NOTE
○ To switch between COLD (green) or HOT
(green) during operation, switch o ff the power,
wait approximately 1 hour and then make your
selection.
(3) Press the temperature selector switch to select
either HIGH, MID or LOW.
NOTE
○ The unit’s fan will automatically switch on or o ff to
control temperature. This is not a malfunction.
○ Should all lamps fl ash on and o ff , there is
a problem with this product. Immediately
discontinue use and contact the store where you
purchased this product.
Mode selector
switch
Green
Green
Fig. 19
Green
Green
Green
Power selector
switch
Fig. 20
Mode indicator
switch
Fig. 18
Power indicator
lamp
Power switch
000Book̲UL18DA̲ChS.indb 36 000Book̲UL18DA̲ChS.indb 36 2018/07/19 14:04:41 2018/07/19 14:04:41