HIKOKI UL 18DA, Инструкция по эксплуатации, Страница: 28 / 48

English
28
32. Do not leave unattended with moisture in the unit.
Leaving it unattended in this manner can result in mold growth. Wipe away any
remaining moisture and make sure the unit is dry.
33. Pulling the unit on poor pavement surfaces or when it is full can result in accidents
such as falling.
34. Do not fully wash the unit.
Water could leak through gaps and soak the insulation, resulting in mold growth.
35. Do not wash the unit with polishing powder, a scrubbing brush, boiling water,
thinner, benzine or other organic solvents.
36. Avoid strong impacts and vibrations when transporting the unit.
Failure to do so may result in damage.
37. When not in use, make sure that the jack cover of the power jack and the battery
cover remains closed.
Failure to do so may result in damage.
38. When using the DC 12V car power source, always disconnect the connection plug
before switching o ff the engine.
The power of certain vehicles do not cut o ff when the engine is switched o ff .
Leaving the connection plug connected could result in overcharging the battery.
39. Do not use the product in the trunk of a car.
High temperatures could result in damage.
CAUTION ON LITHIUM - ION BATTERY
To extend the lifetime, the lithium-ion battery equips with the protection function to stop
the output.
In the cases of 1 to 2 described below, when using this product, even if you are pulling
the switch, the motor may stop. This is not the trouble but the result of protection
function.
1. When the battery power remaining runs out, the motor stops.
In such case, charge it up immediately.
2. If the battery is overheated under overload work, the battery power may stop.
In this case, stop using the battery and let the battery cool. After that, you can use
it again.
Furthermore, please heed the following warning and caution.
WARNING
In order to prevent any battery leakage, heat generation, smoke emission, explosion and
ignition beforehand, please be sure to heed the following precautions.
1. Make sure that swarf and dust do not collect on the battery.
○ During work make sure that swarf and dust do not fall on the battery.
○ Make sure that any swarf and dust falling on the power tool during work do not
collect on the battery.
○ Do not store an unused battery in a location exposed to swarf and dust.
○ Before storing a battery, remove any swarf and dust that may adhere to it and do
not store it together with metal parts (screws, nails, etc.).
000Book̲UL18DA̲ChS.indb 28 000Book̲UL18DA̲ChS.indb 28 2018/07/19 14:04:41 2018/07/19 14:04:41