English
6
3. Don’t let the cord touch the wool bonnet during its
operation, for the rotating wool bonnet may catch the
cord and get caught it in.
4. Switching on the polisher
Pulling the trigger of switch and push the stopper, it
keeps the switched-on condition and it is convenient for
the continuous operation. When switched o
ff
, the stopper
can be disengaged by means of pulling the trigger again.
5. Precaution after use
Do not lay the polisher down immediately after using on a
place where there are many shavings, much dirt and dust
until it has completely stopped revolving.
CAUTION
When the polisher is not in use, the power source should
be disconnected.
MAINTENANCE AND INSPECTION
1. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
2. Maintenance of the motor
The motor unit winding is the very “heart” of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
3. Inspecting the carbon brushes (Fig. 4)
The motor employs carbon brushes which are
consumable parts. Since an excessively worn carbon
brush could result in motor trouble, replace the carbon
brushes with new ones which have the same carbon
brush No. shown in the
fi
gure when they become worn to
or near the “wear limit”. In addition, always keep carbon
brushes clean and ensure that they slide freely within the
brush holders.
4. Replacing carbon brushes
Disassemble the brush caps with a slotted-head
screwdriver. The carbon brushes can then be easily
removed.
5. Service parts list
A: Item No.
B: Code No.
C: No. Used
D:
Remarks
CAUTION
Repair,
modi
fi
cation and inspection of HiKOKI Power
Tools must be carried out by an HiKOKI Authorized
Service Center.
This Parts List will be helpful if presented with the tool to
the HiKOKI Authorized Service Center when requesting
repair or other maintenance.
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
MODIFICATIONS
HiKOKI Power Tools are constantly being improved
and modi
fi
ed to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or
design) may be changed without prior notice.
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci
fi
cations herein are subject to
change without prior notice.
000Book̲SP18SB̲ChTA.indb 6
000Book̲SP18SB̲ChTA.indb 6
2018/03/14 12:10:53
2018/03/14 12:10:53
