5
English
DEMOLITION HAMMER SAFETY WARNINGS
1.
Wear ear protectors.
Exposure to noise can cause hearing loss.
2.
Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.
4. Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
5. Even when the switch is on, the motor is running and
the tool head is pressed to the demolition surface,
the demolition hammer sometimes does not start
operating. In these instances, turn the switch off,
press the tool head against the demolition surface
again, and turn the switch on and off. This should
start the demolition hammer operating. Repeat this
procedure for several minutes, and the demolition
hammer will heat, after which it will operate when
switched to ON-LOCK.
STANDARD ACCESSORIES
(1) Case ............................................................................. 1
(2) Bull Point ..................................................................... 1
(3) Side Handle ................................................................. 1
(4) Front Cap ..................................................................... 1
(5) Dust Cover .................................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
䡬
Crushing
䡬
Asphalt Cutting
䡬
Surface Roughing
䡬
Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without
notice.
NOTE:
The earth adapter and anchor adapter sold separately
cannot be used.
* Be sure to check the nameplate on product as it is subject to change by areas.
SPECIFICATIONS
Voltage (by areas)*
(230V, 240V)
Power Input
950 W*
Full-load Impact Rate
3000min
–1
Weight (without cord, side handle)
5.9 kg
(1) Cutter
(1) Bushing Tool
(2) Shank
(1) Bull Point
Overall Length: 280, 450 mm
(1) Scoop
(1) Rammer
(2) Shank
䡬
Tamping
䡬
Syringe (for debris removal)
䡬
Scooping Work
01Eng_H45SR_WE
08/12/12, 12:04
5
Содержание H 45SR
