English
50
9. About the mode change function
The unit has “Transmission mode” and “Auto mode”.
○
With Transmission mode, the grinder’s number of revolutions can be set at one of
fi
ve
stages.
When operating in Transmission mode, the set number of revolutions will be maintained
regardless of changes in load.
○
With Auto mode, you can lower noise and vibration by lowering the maximum number of
revolutions while in a no-load state.
While in Auto mode, the number of revolutions will be raised if the load becomes greater
during operation.
On the other hand, the number of revolutions will be lowered if the load decreases during
operation. (
Table 5
)
○
Set the mode and dial according to work application.
NOTE
Do not give a strong shock to the switch panel or break it. It may lead to a trouble.
Table 5
Mode
Status
Number of Revolutions
(r/min)
Use
Transmission
Dial Settings
1
3000
Grinding stainless steel
Rust or paint removal
Grinding,
fi
nishing
2
4750
3
6500
4
8250
Rough grinding,
cutting
5
9500
Auto
A
5500
Light work, Standby state
9500
Grinding, cutting
GRINDER OPERATION
CAUTION
To extend the lifetime, the lithium-ion battery equips with the protection function to
stop the output. Therefore, if the tool is overloaded, the motor may stop. However,
this is not the trouble but the result of protection function. In this case, release the
switch of tool and eliminate the causes of overloading.
NOTE
○
To prevent injuries, this product has a function that prevents unexpected motor rotation
when the battery is inserted. The motor will not run if the battery is inserted while the switch
is still ON. After installing the battery, turn the switch o
ff
and then back on again.
000Book̲G3610DA̲ChS.indb 50
000Book̲G3610DA̲ChS.indb 50
2021/05/10 12:09:08
2021/05/10 12:09:08
