English
38
ADDITIONAL SAFETY WARNINGS
1
Ensure that the depressed center wheel to be utilized is the correct type and free of
cracks or surface defects. Also ensure that the depressed center wheel is properly
mounted and the wheel nut is securely tightened.
2. Con
fi
rm that the push button is disengaged by pushing push button two or three
times before switching the power tool on.
3. To prolong the life of the machine and ensure a
fi
rst class
fi
nish, it is important that
the machine should not be overloaded by applying too much pressure. In most
applications, the weight of the machine alone is su
ffi
cient for e
ff
ective grinding.
Too much pressure will result in reduced rotational speed, inferior surface
fi
nish,
and overloading which could reduce the life of the machine.
4. The wheel continues to rotate after the tool is switched o
ff
.
After switching o
ff
the machine, do not put it down until the depressed center
wheel has come to a complete stop. Apart from avoiding serious accidents, this
precaution will reduce the amount of dust and swarf sucked into the machine.
5. When the machine is not use, the power source should be disconnected.
6. Be sure to switch OFF and pull out the battery to avoid a serious accident before
the depressed center wheel is assembling and disassembling.
7. Be careful of brake kickback.
This cordless disc grinder features an electric brake that functions when the switch
is released. As there is some kickback when the brake functions, be sure to hold
the main body securely.
8. Do not use the product if the tool or the battery terminals (battery mount) are
deformed.
Installing the battery could cause a short circuit that could result in smoke
emission or ignition.
9. Keep the tool’s terminals (battery mount) free of swarf and dust.
○
Prior to use, make sure that swarf and dust have not collected in the area of the
terminals.
○
During use, try to avoid swarf or dust on the tool from falling on the battery.
○
When suspending operation or after use, do not leave the tool in an area where it
may be exposed to falling swarf or dust.
Doing so could cause a short circuit that could result in smoke emission or
ignition.
PRECAUTIONS FOR BATTERY AND CHARGER
1. Always charge the battery at an ambient temperature of -10–40°C. A temperature of
less than -10°C will result in over charging which is dangerous. The battery cannot
be charged at a temperature greater than 40°C.
The most suitable temperature for charging is that of 20–25°C.
2. Do not use the charger continuously.
When one charging is completed, leave the charger for about 15 minutes before
the next charging of battery.
000Book̲G3610DA̲ChS.indb 38
000Book̲G3610DA̲ChS.indb 38
2021/05/10 12:09:06
2021/05/10 12:09:06
