HIKOKI CJ 65V3, Инструкция по эксплуатации

Страница: 9 / 64

9
English
h) Keep handles and grasping surfaces dry, clean
and free from oil and grease.
Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in
unexpected situations.
5) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool is
maintained.
PRECAUTION
Keep children and infirm persons away.
When not in use, tools should be stored out of reach
of children and infirm persons.
JIG SAW SAFETY WARNINGS
1. Hold the power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
2. Use clamps or another practical way to secure and
support the workpiece to a stable platform.
Holding the workpiece by hand or against your body
leaves it unstable and may lead to loss of control.
SPECIFICATIONS
Model CJ65V3
Voltage (by areas) * (110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
Power input 400 W*
Max. cutting depth
Wood: 65 mm
Mild steel: 6 mm
No-load speed 0 – 3000 min
-1
Stroke 18 mm
Min. cutting radius 25 mm
Weight (without cord) ** 1.5 kg
* Be sure to check the nameplate on product as it is subject to change by areas.
** According to EPTA-Procedure 01/2014
STANDARD ACCESSORIES
(1) Blade No.31 .................................................................. 1
For cutting thick lumber
(2) Splinter guard ............................................................... 1
(3) Chip cover .................................................................... 1
(4) Hexagonal bar wrench ................................................. 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
(1) Blades, No.1 – No.6, 31*
* No.31 Blade is a standard accessory.
(2) Guide
Optional accessories are subject to change without notice.
APPLICATIONS
○ Cutting various lumber and pocket cutting
○ Cutting mild steel plate, aluminum plate, and copper
plate
○ Cutting synthetic resins, such as phenol resin and vinyl
chloride
○ Cutting thin and soft construction materials
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power source,
use an extension cord of sufficient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
MOUNTING THE BLADE
1. Use the accessory hexagonal bar wrench to loosen
the blade set screws on the blade holder, as shown in
Fig. 1(a) .
2. Holding the blade with its cutting edge facing the front,
insert the mounting portion of the blade into the plunger
groove until it touches the bottom of the groove.
3. As shown in Fig. 1(b), firmly clamp the side screw.
0000Book_CJ65V3.indb 9 2019/02/19 22:10:17