HIKOKI CJ 18DA, Инструкция по эксплуатации

Страница: 16 / 76

16
English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
Symptom Possible cause Remedy
Tool doesn’t run No remaining battery power Charge the battery.
Battery isn’t fully installed. Push the battery in until you hear a click.
Tool suddenly stopped Tool was overburdened Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Battery overheated
Allow the tool and battery to thoroughly cool.
Blade
- can’t be attached
- fall o ff
The shape of the attachment portion doesn’t
match
Use the appropriate blade
(See “Selecting accessories”)
The lever is open. Close the lever.
There is foreign matter inside the blade
holder.
Remove the foreign matter.
Switch can’t be pulled
Lock-o ff button is pushed in.
Release the Lock-o ff button.
An abnormal high-pitched
noise occurs when the
trigger switch is pulled.
The trigger switch is being pulled only
slightly.
This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.
Blade wears out too
quickly.
Proper machine oil not used when cutting
metallic materials
Use machine oil (turbine oil, etc.)
Too much applied pressure during operation During operation, lighten the applied
pressure.
Unable to properly cut. Blade is inappropriate for the quality and
thickness of the material to be cut
Use the proper blade
(See “Selecting accessories”)
Speed and orbital position are inappropriate
for the quality and thickness of the material
to be cut
Set the appropriate speed and orbital
position
(See “Mounting and operation” Fig.14
–
19
on page 13)
Blade is worn, degraded or damaged Replace with a new blade.
0000Book̲CJ18DA̲Asia.indb 16 0000Book̲CJ18DA̲Asia.indb 16 2020/05/21 17:54:15 2020/05/21 17:54:15