HIKOKI C 3606DPA, Инструкция по эксплуатации

Страница: 12 / 324

12
English
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classi fi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
○ If the BSL36B18 is installed in the power tool, the power
output will exceed 100 Wh and the unit will be classi fi ed
as Dangerous Goods for freight classi fi cation.
Power Output
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS (Fig. 1 – Fig. 24)
Adjuster
Connector
Guard
Glass guard
Locking screw (diagonal cuts) (Rear)
Clamping lever (for rip fence) (Rear)
Clamping lever (for rip fence) (Front)
Undercut button
Locking screw (diagonal cuts) (Front)
Scale (diagonal cut angle)
Sub handle
Locking button
Stopper
Lock lever
Rotary button
Base
Saw blade
Hexagonal bar wrench
Battery
Nameplate
Dial
Handle
Trigger switch
Lock-o
ff button
Motor
Cutting indicator
Rip fence
Latch
Charge indicator lamp
Read-o
ff edge
Symbol “saw blade changing”
Saw blade
fi xing screw
Washer (B)
Read-o
ff edge of guide rail “GR”
Adjusting screw (A)
Adjusting screw (B)
Marking
Guide grooves
Battery level indicator switch
Battery level indicator lamp
Dust bag
Rubber cover
USB port
USB cable
Air gun
0000Book̲C3606DPA.indb 12 0000Book̲C3606DPA.indb 12 2022/09/01 15:58:20 2022/09/01 15:58:20