Heat Resistant Bullet Camera · Quick Start Guide
2
Table 2-2
Description of Device
No.
Description
1
Alarm Input/Output
2
RS-232 Cable
3
RS-485 Cable
4
CVBS Cable
5
RJ45 Network Cable
6
Power Cable
3
Installation
3.1
Wiring
Please fully take into consideration the installation environment
and position of the device when you plan for the wiring. In order
to make sure the stable power supply and signal transmission,
please closely follow the rules below:
Confirm the installation environment before wiring,
including the wiring distance, wiring environment,
magnetic-field interference, etc.
The rated voltage of the wire should be higher than that the
device requires, so the device can work normally when the
voltage instability occurs.
It’s recommended to use a single complete cable for wiring;
if not, reinforcement measures should be taken to protect
the wiring point between two cables, or the device may
work abnormally due to the circuit aging.
Make sure the device cables are well protected, and take
reinforcement and protective measures during wiring.
Avoid bumping the cables and damaging the magnetic ring,
or the device may work abnormally.
Make sure the cables are not too redundant or stretched too
tight.
The wiring should be completed by professional technicians.
When the device cannot work normally, you can check the
above information for troubleshooting.
3.2
Install the Camera
Before you start:
The bracket is not included in the package. Please purchase it
separately.
Steps:
1.
Drill four holes on the wall according to the dimension of the
wall mounting bracket template.
Figure 3-1
Drill Holes on Wall
2.
Drill four M8 screws into the holes.
Figure 3-2
Drill M8 Screws into Holes
3.
Loosen and remove the screws to dissemble the PT joint.
Figure 3-3
Dissemble PT Joint
Note: ①: PT Joint Bottom; ②: PT Joint Top
4.
Align the four holes on the bracket with the four M8 screws
on the wall, install the bracket on the wall, and tighten the
screws.
