4
Gazebo Takedown
1. Remove pegs and untie ropes on the pegs.
2. Move around the tent and push side wall panels inward so that the gazebo collapses.
3. Push the top panel inward. The tent should now be back on the ground in its flattened state.
4. Gather the corners of the tent and fold the corners together.
5. Take the folded tent and insert it into carry bag. Place the pegs and ropes in bag as well.
NOTE: Do not force the tent when folding. If tent is hard to fold, check for overlaps and entanglements in
the tent.
MAINTENANCE/STORAGE INSTRUCTIONS
• Take down the tent when not in use. Do not leave tent unattended.
• Never store the tent when it is wet. Always let the tent dry before storing it.
• Use extra tie-downs during excessive winds.
• Clean and wipe down the tent before storing it for long periods of time.
• Store the tent in a cool, dry area.
PLEASE READ THE INSTRUCTIONS CAREFULLY
SET-UP STEPS
1.Spread the flysheet out on the ground, as flat as possible
2. Fold up each of the poles, then lift the top panel up, whilst pulling each side panel out by the
corresponding metal pulling loop on either side, then the integral fibreglass poles will simply pop
into place.
These pictures can be instead by the physical photo if need
3.Peg down the four corners of the flysheet to make it stable
TAKE-DOWN STEPS
Push the side metal pulling loop into make the flysheet down ,then push the top panel in, at last
fold it along with the pole
CHECK FOR PARTS ONLINE AT WWW………
OR CALL 000-000-0000
PLEASE READ THE INSTRUCTIONS CAREFULLY
SET-UP STEPS
1.Spread the flysheet out on the ground, as flat as possible
2. Fold up each of the poles, then lift the top panel up, whilst pulling each side panel out by the
corresponding metal pulling loop on either side, then the integral fibreglass poles will simply pop
into place.
These pictures can be instead by the physical photo if need
3.Peg down the four corners of the flysheet to make it stable
TAKE-DOWN STEPS
Push the side metal pulling loop into make the flysheet down ,then push the top panel in, at last
fold it along with the pole
CHECK FOR PARTS ONLINE AT WWW………
OR CALL 000-000-0000
PLEASE READ THE INSTRUCTIONS CAREFULLY
SET-UP STEPS
1.Spread the flysheet out on the ground, as flat as possible
2. Fold up each of the poles, then lift the top panel up, whilst pulling each side panel out by the
corresponding metal pulling loop on either side, then the integral fibreglass poles will simply pop
into place.
These pictures can be instead by the physical photo if need
3.Peg down the four corners of the flysheet to make it stable
TAKE-DOWN STEPS
Push the side metal pulling loop into make the flysheet down ,then push the top panel in, at last
fold it along with the pole
CHECK FOR PARTS ONLINE AT WWW………
OR CALL 000-000-0000
