77
Enable audible alarm (default: Enabled)
When a physical disk fails, the controller will emit an audible sound signaling failure.
This option mutes the alarm.
Set Spin down Idle Disk (minutes) (default: Disabled)
When set, physical drives will spin down a certain amount of time after disk activity
ceases. Only 10, 20, 30, 60, 120, 180, 240 minutes setting are available.
Restrict to localhost access (default: Enabled)
Remote access to the controller will be restricted when
enabled
, other users in your
network will be unable to remotely log in to the WebGUI.
Rebuild Priority (default: Medium)
You can specify the amount of system resources you want to dedicate to rebuilding
the array. There are 5 levels of priority [Lowest, Low, Medium, High, Highest]
Port Number (default: 7402)
The default port that the HighPoint WebGUI listens on is 7402. You may change it to
any open port.
Password Setting
Changing your WebGUI password
Under Password Setting type your new password and confirm it, then click submit
.
Email Setting
You can set the controller to send an email out to recipients of your choosing when
certain events (refer to Event Tab) trigger.
