HIGHLEAD HLK-03, Инструкция по эксплуатации

Страница: 15 / 62

10
5-3 Winding the bobbin thread
★
Please make sure to pull the upper thread out of the needle before winding the bobbin thread
．
(1) Pass through the thread from the thread
stand
○
4 as shown on the right figure .
then
，
wind the thread to the empty bobbin
○
5 in the arrow mark “a” direction couple
times and insert the bobbin
○
5 into the
bobbin winder
○
6
．
(2) Push the adjust lever
○
7 in the arrow mark
“b” direction
．
※
Caution: Bobbin winder does not work immediately after Turning ON the power. Perform the bobbin
winding after setting pattern NO. or the like once, pressing the key, and making the Sewing
LED light up.
(1) Press key to make the Sewing LED go off.
(2) Select the bobbin winder with key.
(3) Press key. The work clamp feet
⑨
come down and the Sewing LED lights up.
(4) When the pedal
⑧
is depressed, the sewing machine rotates.
(5) When the pedal
⑧
is depressed again, or key or key is pressed, the sewing machine stops.
(6) When key is pressed, the Sewing LED goes off, the work clamp feet go up and key become
effective.
5-4 Settling the bobbin
(1) Set the bobbin
○
2 into the bobbin case
○
1
．
(2) Pull the bobbin thread
○
3 into the slit
○
4 and pass the
thread through the thread hole
○
5
．
(3) At this time
，
pull the bobbin thread
○
3 then
，
check with
the bobbin
○
2 if it is rotaled to the arrow direction
．
if it is
not
，
set the bobbin
○
2 into the bobbin case
○
1 over again
to get the proper rotation.