LOW PASS/SUB SONIC
LOW PASS -
Controls the frequency response of your speakers upwards and is continously
variable from 35Hz to 250Hz.
SUB SONIC -
Eliminates the lowest frequencies to protect the speakers from damages. These
low frequencies can cause damages. The frequency is adjustable from 15 Hz to 35 Hz.
Line
I
nput -
Full range line input
connect with the
Head unit.
Bass EQ -
Allows you
to adjust the bass boost
from 0dB up to 18dB at
45 Hz
Protect - LED
Red LED is illuminated:
a) Overheated
b) Speaker wires shorted
c) Overload (Impedance, less Power)
d) Amplifier is damaged
Should the amplifier go into proteciont mode, simply
disconnect all RCA and speaker leads, while
k12 volt, power ground and remote leads
connected. Now turn the amplifier back on, and if
the PROTECT-LED lights, the amplifier has an
internal fault. If not, plug the RCA cables back, and
reset the amplifier. If it goes into protection mode
now, the fault lies in the input, either with bad cables
or source unit. If the amplifier seems fine with RCA
cables plugged in, connect the speakers, one at a
time, and if one of the speakers or its wiring is faulty,
it will activate the diagnostic system.
LINE INPUT---BALANCED---SUBSONIC---BASS EQ---REMOTE---LOW PASS---PHASE---LEVEL---POWER---LINE OUT
PROTECT
LCH
RCH
L
R
15Hz 35Hz 0dB 18db 35Hz 250Hz 0 180 9V 0.2V
INPUT
9
Monoblock-Amplifier- Functions and Controls
BXi 750 / BXi 1100
D / BXi 1600
D
Remote -
Connection
for remote control.
Allows you to adjust the
subwoofer from your
Level -
This allows you to
match the input sensitivity
from 9 Volts to 0,2 Volts.
Power - LED
Green LED is illuminated
amplifier is on.
Line Out -
Full range
output that allows you
to use additional
amplifiers.
Phase -
Phase from 0° to
180°.
This allows you to
match the
Balanced Input -
Connect Head unit and
amplifier with a line driver
cable.
(a line driver is needed)
