4.2 RGB LIGHTS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
TO OPERATE RGB LIGHTS:
a. AUTO CHANGE
b. SELECTING COLOR MODE
4.3 CONTROLLER
5. MAINTENANCE, REPLACEMENT, WARRANTY
NOTE:
There is no maintenance required for this light. It is designed to be used only once,
meaning that replacement is necessary if it becomes defective. The repairing is impossible.
NOTE:
To replace the complete light, unfasten it from the bracket. Make sure the new light is
in the same switch.
The warranty is limited to the first retail purchaser, it is not transferable, and does not apply to
products that have been moved from their original installation sites. This warranty does not
cover failures or malfunctions from improper installation and/or operation.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up
of any electric components which have been inserted or handled at locations other than its
own premises.
The user of this underwater light should confirm the warranty period with the product's seller.
When there are any problem during the warranty period, the seller of this product should be
the first person you should contact.
To select the color mode, turn the light OFF for one 1.5 seconds. Continue turning OFF and
ON until the desired light color mode is reached.
NOTE:
When the light is turned OFF for more than 1.5 seconds, it will return to the beginning
of the color cycle (mode 1).
NOTE:
To synchronize several lights to the same color mode, you will need to reset to the
beginning of the color mode sequence. With the lights ON, turn them OFF for more than 5
seconds, then turn ON again. All lights will reset to the Blue (mode 1). If all of the lights are not
in the Blue (mode 1), they have not been synchronized, repeat the steps above.
IMPORTANT:
This section only applies to the RGB or RGBW lights. Pool users and operators
can choose to (or not to) install one (or more) controller to build a fine control system for the
lights.
NOTE:
The specifications of the controller, especially the input voltage, must be well known by
pool users and installers before installation. Failure to do so may cause the injury to person
and damage to both the light and controller.
Turn the light ON, the 16 pre-programmed color modes will begin to run automatically and
cyclically from mode 1 to mode 16, until the light power is off.
NOTE:
The first time the light is turned on, the color begins with Blue (mode 1).
RB: static purple
BG: static cyan-blue
RG: static yellow
RGB: static white
RGB change gradually to G/R/B
R-RG-G slow animation
G-GB-B slow animation
R-G-B fast animation
R-B-G fast animation
G-RB-B-R-RGB-GB-RG
R-G-B slow animation
IMPORTANT: This section only applies to the RGB lights with 12 volt AC input.
See the table below for the color mode sequence.
BLUE: static blue
RED: static red
GREEN: static green
B-BR-R slow animation
RG-GB-BR slow animation
NOTE:
To synchronize several RGB lights to the same color, all lights must be wired into
the same transformer, circuit or switch for synchronization to occur.
6