2.2 INSTALLTING THE LIGHT FIXTURE
2.3 REPLACING THE BULB
Figure 8
Figure 9
Figure 10
WARNING: Use only the special pilot screw provided with this underwater light. This screw
mounts and electrically grounds the mounting parts of the light. Or choose qualified 304# or
better stainless steel pilot screw. Failure to do so may cause serious corrosion of the pilot
screw and the light.
WARNING: Always disconnect the power to the pool light at the circuit breaker when installing
the light. The light must be fully submerged in water before any check for proper operation
after installing.
IMPORTANT: Make sure the new bulb is suitable for this underwater light. It is best that the
new bulb is with the same specifications as the old bulb.
1. Unscrew the pilot screw and pull top of the face ring, remove the light assembly from niche
and gently place assembly on the deck. It is not necessary to drain down the pool.
2. Unscrew the nuts on the back of the light assembly to allow the bottom clamp to be
removed from the light fixture. (See Figure 10 and Figure 11).
3. Install the new bulb.
①
REPLACING A PAR56 BULB
1. The screw holes on the light fixture should be lined up with 12 o’clock position. (See Figure
8).
2. Aim at the screw hole and tighten the fixture to the niche with the screws provided. (See
Figure 9).
4
