Easy HD Expressway!
WWW.HIDES.COM.TW
4
Power and RF-out
1. Connect 12 V DC adaptor (valid DC power range from 9V~24 V)
2. Connect the RF from the F-connector to an antenna or a coaxial cable (to TV’s or STB’s)
The left-upper LED will be lighted if power is on and system starts to boot. If the bootloader failed to run,
the LED will be off even power is applied.
After power on for 20-25 seconds, the front panel will show the status.
The left-lower LED will be lighted if video input (either CVBS or HDMI ) is present and detected.
The 7-seg LED’s show current RF output TV channel number.
Basically, the channel number is consistent to the channel numbering rule of TV/STB receivers. Refer to
appendix for the channel frequency mapping.
If the channel number is 0, the channel frequency and bandwidth is set by PC/NB configuration tool via
USB port.