HID Corporation, 9292 Jeronimo Road, Irvine, CA 92618-1905, USA • Tel: (949) 598-1600, (800) 237-7769, Fax: (949) 598-1690
http://www.hidcorp.com
MaxiProx DFM Reader Installation Manual 5375-901 Rev D
Page
6 of 20
§
FCC Certification
§
European Declaration of Conformity
§
Foreign Countries EMC and/or Type
Approvals
§
Pacemaker wearers should exercise
caution when in close proximity to this
product.
Chapter 2 Installation Procedure
2.1
2.1 Preparation
Preparation
Determine an appropriate mounting position for the MaxiProx. Install an electrical box or drill the
appropriate mounting holes from inside the base with the cover removed for #6 fasteners. For optimum
performance, the Reader should be mounted at least 4 inches away from any metallic surface 12-inch x
12-inch or larger. The Autotune feature automatically compensates for incidental metal such as
aluminum studs and conduit. The best method for installing the MaxiProx is by mounting the back of
the Reader to the mounting surface. Side mounting is usually accomplished with an adapter or spacer
(customer supplied) that mounts to the back of the Reader.
2.2
2.2 Mounting and Installation
Mounting and Installation
§
When fastenin g the MaxiProx to the mounting surface, do not use a metallic fastener larger than a #6 screw.
§
Avoid mounting the MaxiProx closer than 1 meter (40-inches) to another MaxiProx.
2.3
2.3 Mounting Applications
Mounting Applications
§
The MaxiProx may be mounted to a gooseneck that is 1½-inch in diameter with a 4-inch diameter-mounting flange without
degradation of read range. The flange should be mounted to a non-metallic adapter that will ease the installation of the
MaxiProx to the flange. The read range will not be affected.
§
The MaxiProx may be mounted to a 12-inch x 12-inch or larger metal plate with a 4-inch spacer used to separate the Reader
from the plate.
§
Acrylic, Plexiglas, Lexan (polycarbonate) or other suitable plastics may be found in ½-inch to 1-inch stock. Mounting
adapters may be fabricated from these materials that would be sturdy and not affect the performance of the MaxiProx.
Plastic J-boxes can also be used.
2.4
2.4 Cable Preparation
Cable Preparation
Prepare the cable by cutting the cable jacket back 2 inches and strip the wires 1/4-inch. Tinning the
wires is not required.
2.5
2.5 Install Cable
Install Cable
Route the interface cable from the MaxiProx to the Host. Connect the MaxiProx DC power input to the
Host or external power supply. 12VDC or +24VDC can be used.
CAUTION!
The shunt jumper P2 is not installed as the factory default for +24VDC operation. If the jumper is in the
+12 VDC position and +21 to +28.5 VDC is applied, circuit damage can result.
2.6
2.6 Cable Notes
Cable Notes
§
For Wiegand interface cable the maximum length is 500 feet (150m), 50 feet (15m) for RS232, and 4000 feet (1200m) for RS422.
Проектирование
.
Монтаж
.
Продажа
. - http://vskd.ru
