HID ENTRYPROX, Руководство пользователя

Страница: 22 / 38

Page 22 of 38 September 2016
EntryProx User Manual, 4045-905, Rev. C.4
6 Programming
IMPORTANT: READ BEFORE PROGRAMMING THE ENTRYPROX UNIT
• Keep a User List
- When programming cards and PIN codes into your EntryProx, record each
User Location, Card Number, PIN Code and the Name of the User. Use the blank form in
Appendix: A: Users Chart for Record Keeping as a photocopy master.
• Program the New Master Code into Location 0 - Once this is done, the default Master Code in
User Location 1 can be reprogrammed for normal access control use. Write the new code down
and keep it in a safe place.
Note: Changing the Master Code is required for Rev C EntryProx before any programming can
be done. In addition, the User Location 1 is no longer reserved for the Master Code and can be
reprogrammed for any User Type.
• If the Master Code Is Lost:
End Users: Contact your dealer – A service call is required.
Dealers: Call HID Global Technical Support. The proper hex key or security tool will be
need to be used at the customer site.
• Consider a Secure Installation
- For exterior doors or other high-risk locations, a secure
installation is recommended.
6.1 Programming Command Sequences
Command sequences are simply a series of keypad entries to add cards and PINs or change
operating characteristics of the EntryProx unit. There are three basic steps to programming
EntryProx, using the Keypad on the control unit:
1. Place the unit in programming mode:
Press
99 # Master Code *
2. Enter a Command Sequence:
Press a 2-digit command number to enter cards/PINs or specify parameters by pressing
keys in various sequences
3. Exit programming mode:
Press
* to exit