Operating Instruction Manual:
OM-TWS-N-01
Serial Numbers:
All
11
5.3 Setting the Direction of Rotation of the Square Drive
The position of the Square Drive when looking toward the Shroud will determine if the tool is set to tighten
or loosen the nut/bolt (See below).
Looking at the front of the tool, with the reaction arm pointed away from you;
When the square drive extends to the
RIGHT
, the tool is set to
TIGHTEN
the nut/bolt.
When the square drive extends to the
LEFT
the tool is set to
LOOSEN
the nut/bolt.
To change the direction of rotation, proceed as follows:
Press in the push-button release on the drive retaining plate and at the same time pull the square
drive out of the housing.
Release the push button on the retaining plate and allow the retaining plate to drop out of the tool
body into your hand.
Insert the square drive into the cavity on the opposite side of the tool body (where the retaining plate
was previously)
Secure the square drive by installing the push-button release retaining plate onto the end of the
drive.
5.4 Setting the Torque
After determining the required torque, use either the torque conversion chart engraved on the shroud or the
torque conversion charts on page 19 of this manual to determine the pressure necessary to achieve the
desired torque output.
Refer to the pumps operating instructions manual for a detailed procedure for setting the pumps output
pressure to that determined above.
Figure 5.5: Direction of Rotation of the Square Drive
