HF PackerAmp V4, Руководство по монтажу

Страница: 29 / 76

HF PACKER
AMP
V4R6 Page 29
Power Wiring Connections
Connection of Power Wires
Install Rear Panel Power Switch
•
Snap in the power switch with the “1” label towards the
outside.
Install Wiring for Power
•
Crimp one end of a 4 inch length, #14AWG RED Teflon
coated wire to a Blue Flag Terminal.
•
Crimp the other end to a Power Pole (PP) 30A
Terminal.
•
Insert PP Terminal into the RED PP housing.

Note: Use the end of a thin flat blade screw driver to
press the PP terminal into the PP housing until you hear it
click. Use a pull test to be certain the wire is firmly seated in
the PP housing.
•
Plug the Blue Flag Terminal on the Power Switch
outside terminal.
•
Crimp both ends of another 4 inch length , #14AWG
RED Teflon coated wire to a Blue Flag Terminal
•
Plug the Blue Flag Terminal on the remaining Power
Switch terminal.
•
The other end of this 4 inch RED wire will plug on the
circuit board at H1 during circuit board and case
assembly.
•
Crimp one end of a 4 inch length, #14AWG BLACK
Teflon coated wire to a Blue Flag Terminal.
•
Crimp the other end to a PP 30A Terminal.
•
Insert PP Terminal into the BLACK PP housing.
•
Use a pull test to be sure wire is firmly seated in PP
housing.
•
The other end of this 4 inch BLACK wire will plug on
the circuit board H2 during circuit board and case
assembly.