HF PackerAmp V4, Руководство по монтажу

Страница: 26 / 76

HF PACKER
AMP
V4R6 Page 26
•
Place the heat shrink over the coax end with both wires
of each end exiting the tubing. The shield and black
wire are folded back against the coax outer covering.
The black wire is pulled forward to be the same length
as the coax center wire.
•
Crimp Molex pins on both ends of the cable
•
Heat-shrink the cable bare connections with the ½ inch
length of ¼ inch black heat shrink tubing. View the
picture on the next page for the finished cable
appearance.
Low Pass Filter Output Cable Fabrication
•
The top cable is the finished Low Pass Filter Input
Cable.
•
Fabricate the Output cable in a similar manner.
•
Cut the length of the RG174 cable to 5.0 inches.
•
Prepare the ends with the crimp pins.
•
Cut a 5 inch length #24 AWG Red and Black Teflon
coated wire and attach crimp terminals to both ends.
•
Attach the four wires to the four pin Molex connectors.
•
The 4-pin LPF cable plugs in either direction. Make
sure that you have J2 oriented in the same way as
shown in the picture at right.