HF-LPC3X0 Series Wi-Fi&BLE User Manual
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com)
- 40 -
4.
AT+INSTRUCTION INTRODUCTION
4.1.
Configuration Mode
When HF-LPC300 power up, it will default works as transparent transmission mode, then user can
switch to configuration mode by serial port command. HF-LPC300 UART default parameters setting
as below figure,
Figure 40.
HF-LPC300 Default UART Port Parameters
In configuration mode, user can setting the module through AT+instruction set, which cover all web
page setting function.
4.1.1.
Switch to Configuration Mode
Two steps to finish switching from transparent transmission mode to configuration mode.
➢
UART
input “+++”, after module receive “+++”, and feedback “a” as confirmation.
➢
UART input “a”, after module receive “a” and feedback “+ok” to go into
AT+instruction set configuration mode.
Figure 41.
Switch to Configuration Mode
Notes:
1. When user input “+++” (No “Enter” key required), the UART port will display feedback information
“a”, and not display input infor++” as above UART display.
