Hettich AG, Seestrasse 204a, 8806 Baech, Switzerland
Operator Manual_DancerPlus_EN_rev, 1.1
Page 17
2.2.8
Sample racks
There are several racks available for working with the DancerPlus. All racks contain bores enabling each one to
be screwed to the shaking plate. You may also choose the FAST option to connect the rack to the shaking plate
without having to use screws.
The racks are manufactured from anodized aluminium. Flawless functioning of the device can only be guaranteed
if original racks are used.
Self-built racks or setups that are not approved by the manufacturer or its national representative
will result in the voiding of the guarantee on the shaking plate and drive.
Fig. 1: Shaking plate, from below
Fig. 2: Shaking plate with F
4
2
1
3
5
Legend:
1
Feet-set (4 pieces), including O-ring and magnet
CD.M125
2
O-ring, set (4 pieces)
CD.M101
3
Slight elevation at base
4
O-ring, for rack pins, set (8 pieces)
CD.M104
5
FAST rack pins, complete set
CD.Z906
FAST option:
The use of the FAST rack pin set CD.Z906 requires a FAST rack or a later possibility of conversion.
The set includes:
Rack pins (4 pieces)
2 O-ring sets, CD.M104
1 tube of grease, 4051
