Heta SCAN-LIINE 80 XL, Инструкции по эксплуатации и монтажу

Страница: 6 / 28

6
Never fill firewood over the stove’s max. fill line.
See fig. 5.
reduced burning
The stove is well suited to intermittent use. If you
wish to operate the stove with reduced output,
simply insert smaller volumes of wood at each fi-
ring, and apply a lower airflow. However, remem-
ber that the secondary combustion air supply
must never be shut off completely during firing.
It is important to keep a good bed of embers.
Gentle heat is released when the fire settles - i.e.
when the wood no longer generates flames and
has been converted to glowing embers.
optimal firing
To achieve optimal firing and the highest possi-
ble effect, it is important to make sure that the air
supply is used correctly. As a general rule, the
secondary air is to be used to control the fire to
ignite the flue gases. This produces a high effect
and keeps the glass panel completely clear of
soot as the secondary air “washes” down over
it. Please note that the stove will, naturally, pro-
duce soot if both the start-up mechanism* and
secondary air intakes are closed completely. This
will prevent oxygen from being drawn into the
stove, and the viewing window and other parts
will become covered with soot. If this situation is
combined with firing with wet wood, the build-up
of soot can become so thick and sticky that the
sealing rope can, for example, become detached
when the door is opened the next day.
risk of explosion
After you add new fuel, it is very
important that you do not leave
the stove unattended until the
wood is burning constantly
.
This will normally occur within 30 to 60 seconds.
A risk of explosion can possibly arise if too much
wood is placed in the stove. This may result in
1
emptying the ash pan
The ash pan is located behind the large pull-
out front (see fig. 1).
By using the shaker grate, it rotates back and
forth so the ash falls through the holes and into
the ashtray. It is advantageous to leave a layer
of ash in the bottom of the combustion cham-
ber on top of the grate as insulation.
Be careful when emptying the
ashes out. There can be hot
embers left for a long time.
Never empty ash into a combusti-
ble container.
The ashtray must be secure and must not be
able to move after being set in place.
Do not fire in the oven if the ashtray is not in
place.
The warranty is void if it is not complied with.
the production of large volumes of gas, and this
gas can explode if the intake of primary and se-
condary air is insufficient.
It is an advantage always to leave some ash ly-
ing in the bottom of the combstion chamber.
5
1 2
3
4