hesotec electrify eSat r20, Инструкция по установке и эксплуатации, Страница: 12 / 28

Installation 9
3.3 Assembly of Charging Station
DANGER !
Safety note on a hazard with electrical voltage
Make sure that the supply line is de-energized at the time of installation.
Failure to observe the safety instructions can lead to a risk of death due
to electrical voltage.
The electrify charging station eSat should only be installed by qualified personnel. Please
refer to the respective subchapters for the respective assembly steps.
Make sure that the
supply line is de-energized at the time of the assembly!
3.3.1 Assembly with Montage with accessory “Foundation Frame”
The electrify charging station eSat is already pre-assembled in the factory. To assemble the
charging station, in combination with the accessory "foundation frame", proceed as follows:
Installation in combination with foundation frame
1. First loosen the 3 side screws at the lower end of the charging station.
(similar to DIN 7991 M5x12 A2)
2. Then gently pull the black socket out of the charging station.