Herutu POKAYOKE TWF-600R, Руководство по эксплуатации

Страница: 11 / 16

5
Outline of operation
４．
Outline of operation
４−１．
Normal operation
Once this machine receives two kinds of codes, namely, ID1 and ID2, which were previously
logged in, the contact output of either output 1 or output 2 runs during the preset time just as
Receiving lamp 1 or Receiving lamp 2 lights on depending on the received code.
When the code transmitted from Transmitter deployed can only correspond to the output 1, the
output 2 becomes unused (when the input point number of Transmitter is 1-point).
You can select the desired contact output time from among four types of 200ms, 400ms,
600ms and 800ms.
Setting is already established for this machine to prevent double counting in such a way that
next signal cannot be received for 300ms after the last signal is received(unacceptable to
change).
４−２．
ID login
Before using this machine, login the ID to decide the ID you need to receive.
You can login two types of ID1 and ID2. Operation can run while only ID1 is logged in with ID2
not being logged in. Besides, the same ID code for between ID1 and ID2 can be set, however,
only the output for ID1 can run in this case.
Also possible to clear the already logged in ID.
Log in and clear the ID according to the following ways:
To login the ID
①
Turn on the Power switch while pushing the Receiving lamp corresponding to the ID you
need to log in.
ID1
→
ID LOGIN SWITCH1 ID2
→
ID LOGIN SWITCH2
(Receiving lamp can also be used as ID LOGIN SWITCH)
②
Verify that the ID LOGIN SWITCH corresponding to ID you need to login is blinking (at
interval of 0.5sec). If it does not blink, try again.
③
Within 30-second put the Transmitter of the ID you need to login into transmitting
condition once.
④
Within 5-second without a break put it into transmitting condition again.
⑤
Once ID is logged in, blinking of ID LOGIN SWITCH turns into lighting.
⑥
After login is finished, turn off the power once and then turn on the power again before
use.
Precautions during operation
*Do not operate another Transmitter in the vicinity of Receiver during login operation.
It may cause an incorrect login.
*Unless login operation is completed within the given time, the ID LOGIN SWITCH will light
off. In such case, try again from the beginning.