Page | 5
Fix to the wall, reconnect ribbon cable and close
Install the base plate over the pattress and onto the wall, using the screws
provided.
Then reconnect the ribbon cable.
Replace the faceplate (bottom edge first).
Start WH1 for the first time
Turn the mains
power on, the WH1 will default to the “Quick Actions”
screen. All interaction with the WH1 proceeds from this screen. To set the
day and time, press the
icon at the bottom left.
Set the date & time
Use the up and down arrow keys to set the day of the week and the time
(hours and minutes, 24 hour clock).
Press
to save your settings.
Press
to return to the Quick Actions screen.
2.
PAIRING WITH AN R1
The WH1 must be “paired” to R1 units. This allows
the WH1 to
communicate with the R1 and control the heaters. Pairing can only be
carried out once the R1 units are installed and the power supply is on.
From the Quick Actions screen click the “house” icon in the bottom right
to go to the “Manage Zones” scr
een below.
Select the icon of your first zone by pressing it (long press).
Refer to section 5 to learn about setting up and using zones.
Select the first grey R1 icon (long press) until the WH1 goes to the pairing
page which says “Waiting for connection…”
On the R1, press and hold the Boost button for 5 seconds until the
“Heating On” LED flashes quickly.
After 5 more seconds the heating on LED should stop flashing and the R1
receiver will be paired to the controller. (R1 instructions also contain
pairing instructions). There is a dustbin icon allowing you to reject the
pairing at this point should you wish to. You can also delete a pairing this
way in the future.
5 more R1s can be added to this first zone. Alternatively you can start
adding R1s to the second zone and so on.
