CAUTION:
•
Ensure mains power is OFF before commencing installation.
•
The supplied mains cable must not contact the top surface of the heater during operation.
•
Heater must not be located immediately below a socket outlet. Electrical connections must be made outside of the footprint
of the unit to avoid heat build-up. If the heater is to be mounted on an incline (e.g. sloping roof), ensure the electrical
connection is located below the lowest end of the heater.
•
Joists, beams and rafters shall not be cut or notched to install the appliance.
•
This heater is not intended for ceiling-recessed installation. Do not install pointing directly downwards.
•
The identification mark and model reference should be visible after installation.
•
The CALIFORNIA must not be attached facing or close to any combustible material (eg, wood or PVC cladding, fascia or soffit)
or other materials that could blow onto the heater.
•
The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C must be protected,
for example, by sleeving having an appropriate temperature rating.
•
Exercise caution when siting the heater stand that the heater cannot accidentally be touched, knocked-over or that the wire
causes a tripping hazard.
•
Never place the stand and heater next to a swimming pool, pond or other water source.
INITIAL USE:
There may be an odour or vapour from the heater on initial use or if heater has not been used for an extended period. This is
normal.
OPERATION:
The Herschel CALIFORNIA is operated from the remote control supplied with the heater.
Insert 2 x AAA Alkaline batteries into the remote control.
1.
POWER BUTTON: Turns heater on or off.
2.
UP BUTTON: Increases the temperature and timer level.
3.
DOWN BUTTON: Decreases temperature and timer level.
4.
LEVEL BUTTON: Use to adjust heat levels (L1-L2).
Press the Level button then use the
up and down buttons (2 and 3) to increase or decrease the heating level.
5.
TIMER BUTTON: Use to set the timer from T0 – T9 (o-9 hours). Adjust using buttons 2
& 3 to the number of hours you would like to set.
All Herschel remote controls have the same frequency, so it is possible to control several
heaters with just one remote.
USER MAINTENANCE:
The heater may be wiped-down with a soft damp cloth. Do not use abrasive detergents to clean the unit. In marine environments,
the unit may be gently sprayed clean with clean water with the POWER TURNED OFF and completely cool. After cleaning, it is
advisable to warm the heater for 10
–
20 minutes to dry the unit and prevent staining.
The lamp used in the Herschel CALIFORNIA is Ultra long life (10,000 hours). Changing the lamp should only be carried out by
suitably qualified personnel using the instructions available on Herschel’s website.
Remote Control Function
Button Function (Heater On)
Function (Heater Off)
LED Display on Heater
1
Turns heater on or off
2
Increase Heat Level or
Timer hours
Turns heater on to
Level 1 (minimum)
L1
3
Decrease Heat Level or
Timer Hours
Turns heater on to
Level 2 (Maximum)
L2
4
Enable Heat Level
adjustment
L [n]
5
Enable Timer adjustment
T [n]
