Herma LP Morgan Dipper, Руководство пользователя

Страница: 20 / 29

20 | installation instructions
Electrical
Installation
Electrical Installation
The Dipper is supplied with a unique control unit that can be adapted to just about
any installation requirement.
It operates via dry contacts, but can be easily upgraded to a 12V trigger, Infra Red,
Radio Frequency remote control, or even RS232.
A Maintained, Single Pull, Single Throw Switch (a normal light switch) comes
supplied as standard. or alternatively you can use a single relay. Open circuit is
up, close circuit is down.
You do not need to be a qualified electrician to wire the Dipper , as all circuiting is
24V, however Herma will not accept responsibility for damage incurred by faulty
or incorrect wiring.
The power supply and motor are pre-wired, so all you need to do is attach relay
or motor cable and switch as shown in the following diagram.
The switch needs
to be wired into the “Switch Up” and “Common” terminals.
PROTECTIVE ENCLOSURE CONTROL UNIT
POWER IEC LEAD
WALL SWITCH