HERKULES L1200S, Руководство пользователя

Страница: 8 / 15

Check the weight of the vehicle to be sure that it does not exceed the rated load capacity of the lift: 5,000 lbs.
Drive the vehicle onto the lift so that it is approximately centered by weight over the center of the lift. Once the vehicle
is in the desired position, set parking brake and put the ramps into the locked position by tilting them up (see fig.8).
To raise the lift, press the pedal of the foot controller assembly toward the UP position. Hold the pedal in the UP position
until vehicle has reached the desired working height, then release. The mechanical safety arms will automatically
fall into position as the lift rises.
Do not continue to push the control lever after lift is fully raised, even though safety valve will prevent
over-inflation of air bag.
NOTE: Check the stability of the vehicle during the lifting process, and when vehicle is at desired working height.
If vehicle is unstable, immediately stop the lifting process, slowly lower the lift and reposition the vehicle.
To lower the lift, press the pedal of the foot controller assembly towards the DOWN position. Hold the pedal in the DOWN
position until the lift is completely lowered. The mechanical safety arms will swing up during descent.
It may be necessary to raise the lift slightly before lowering to relieve pressure on safety arms.
NOTE: Check the stability of the vehicle during the lowering process. If vehicle is unstable, immediately stop and
diagnose the issue before continuing to lower the lift.
Once the lift is completely lowered, lower the ramps by pulling up and away from the pivot and drive the vehicle clear of the lift.
fig.7
fig.8
STEP 5
STEP 1
Operation
STEP 2
STEP 3
STEP 4
73.313"
42.313"
Locked Position
Page 8 of 15